How to install your iO-LINK - Grax

How to install your iO-LINK - Grax

How to install your iO-LINK iO-LINK creates a tvLINK enabled RF output for new Sky HD set top boxes with no RF2 output. Once installed the iO-LINK ca...

195KB Sizes 0 Downloads 6 Views

How to install your iO-LINK

iO-LINK creates a tvLINK enabled RF output for new Sky HD set top boxes with no RF2 output. Once installed the iO-LINK can be connected to an in home distribution system for viewing at multiple TV locations.

Dish Second TV

Main TV

Aerial In

Power

SCART

Diagram not to scale

For best results, have your iO-LINK installed by a professional satellite installer.

Dish input HDMI

RJ45

USB

Telephone IO Port line

Before you install your iO-LINK: Ensure you have a coaxial cable linking between your SKY box and your second TV

Installing your iO-LINK 1.

Switch off the SKY HD mini STB and disconnect the mains plug.

2.

Connect the iO-LINK directly to the IO port located on the back of the SKY HD mini STB.

3.

Connect one end of the coaxial cable (female connector) to the “RF out” of the iOLINK and the other (male connector) to your second TV.

4.

Connect your aerial feed to the “RF in” connector of the iO-LINK, if off air terrestrial is required.

Tuning your second TV Perform either an auto or manual scan on your second TV as per your TV’s instructions; to find your SKY STB’s output (default Ch68). Alternatively change the SKY STB output channel by following the instructions below. 1. Press the SERVICES button on your Sky Remote Control. 2. Press the right arrow button on your Sky remote control (SETTINGS) 3. Press the down arrow button on your Sky remote control to highlight PICTURE 3. Press 0 then 1 then the SELECT button and SETUP will be highlighted 4. Press the right arrow button 3 times to highlight RF OUT 5. Press the down arrow button and use the number buttons to change the channel number currently showing as channel 68. (pre-set from the factory). Choose a channel between 21 & 69. (the most common being 21, 26, 47, 69) 6. Press the down arrow button and use the right arrow button to change the RF Outlet Power Supply setting from OFF to On 7. Press the Green button to save the new settings and then press the Sky button to return to normal viewing. 8. Finish by returning to your second TV and performing a retune.

01621 744322 www.tvlink.co.uk

BSkyB and Global Invacom Ltd cannot be held responsible for damage caused to equipment during or following the installation of the iO-LINK.